The Code Systems CRCX-3 is Code Alarms standard 2 button replacement remote. This remote works for multiple different systems that code alarm used to offer. Remember that you cannot replace your remote by the "Look" of your system. We need the model of the system installed in the vehicle in order to ensure the correct replacement. The module under the "Drivers Side Dashboard" typically has the model number located somewhere on the box.
This remote Matches most FCC ID:GOH-MM6-101890
 
Customers who purchase this remote are urged to keep the original box and the contents inside until they successfully program this remote. This item is
NON-RETURNABLE if the original box and equipment are not present.
 
 
Systems Utilizing this remote:

  • Pro 100

  • Pro 200

  • Pro 750

  • Pro 1000

  • Pro 3000

  • Pro 3500

  • Elite 911

  • Elite 950

  • Elite 1100

  • Elite 1500

  • Elite 2000 SE

  • Elite 4500

  • RCS-2

  • RKE-1

  • CSM 2.5

  • Surestart SE

  • Surestart SE 433
Code Alarm CRCX-3 Remote Control
$39.99
Add To Cart
 
There are other systems that may also use this remote. Contact us for compatibility questions at 866-774-7367
 

Question: How do I program or re-program my remote control?
Answer: The most well known way to program you remote control is the following: There is usually a black disarm button located under the dash area somewhere or on the drivers kick panel area. What you need to do is open the drivers door so the interior light of the vehicle is ON. Turn the key to the run position (As if the vehicle was running) and hold the disarm button down until you hear the alarm cycle. You will hear 3 chirps usually and the locks, if you have them attached will go up and down with the 3 chirps. While still holding the button down, press the first button on your remote, sometimes known as the arm button or upper left hand button. Once you press this button, the alarm should cycle if it programs. Then press the first button on the 2nd remote control and you should hear the alarm cycle. The alarm has 4 slots to program. So when you do the first remote, then the 2nd, please do the first remote then the 2nd again, so basically you are programming each remote 2 times. If you have a 4 button remote, you must press the first button, or upper left hand button, then the 3rd button or lower left hand button, then do this with the 2nd remote as well. Once this is done, let the button under the dash go, turn the key off and your done. IF YOUR ALARM DOES NOT GO INTO PROGRAM MODE, THERE COULD BE A PROBLEM WITH THE INSTALLATION OR SYSTEM. THE SYSTEM MUST SEE THE INTERIOR LIGHT OF THE VEHICLE ON AND THE DISARM BUTTON HELD DOWN IN ORDER FOR THE UNIT TO GO INTO PROGRAM MODE.
 
Code Alarm/Audiovox Technical Support is at 1800-421-3209